27 - ENGLISH
6.5.3 ADJUSTING THE PRESERVATION TEMPERATURE IN THE TUB
If the preservation temperature of the product
in the tub is not satisfactory or if on the
contrary is so low that it created ice along the
walls of the tub, it is possible to change the
value directly from the push button control
panel by following the instructions below:
-
Make sure the machine is turned on, it
contains enough product and is set for the
PRESERVATION function.
-
At any time, to enter the mode to adjust the
texture, press and hold the PRESERVATION
and SET keys until the display shows the last
set of temperature programmed. The SET
LED turns on.
-
The LEDs of the UP (
Ÿ
),CONFIRM (
ŻŹ
)
and DOWN (
ź
) keys light up and the
numbers relative to the temperature setting
to be configured, expressed in centigrade
degrees between 0° and 10°, appear on the
display: press the “UP (
Ÿ
)” and “DOWN (
ź
)”
keys to increase or decrease this value.
-
Subsequently, press the CONFIRM (
ŻŹ
)
key to save the new temperature value
programmed.
To adjust the storage temperature in the tank
correctly it is important that the level of
mixture is always greater than the minimum
allowed (low mixture LED off) and that after
each change of the temperature from the
push button control panel the user waits at
least 2 hours before proceeding with further
adjustments.
Summary of Contents for KISS 3 POWER Series
Page 47: ...ENGLISH 46 ...