ENGLISH - 32
SANITIZING REMOVABLE PARTS OPTIONAL
REMOVING
AND
CLEANING
THE
DOOR
OPTIONAL
x
Remove the 2 knobs that block the door to the front
of the machine and place it on a clean work surface
to disassemble its parts:
1. Pull the dispenser lever down and remove the
locking pin of the distribution lever.
2. Remove the distribution lever and remove the
piston by pulling it upwards.
3. Remove the OR gaskets with the designated tool
supplied.
4. Remove the counter-beater and the plastic
bushing.
5. Immerse
the
previously
disassembled
components into the tub with the sanitising
solution and brush the surfaces with care. Pay
special attention to the running chamber of the
dispenser piston, to the bushing of the counter-
beater and to the seats of the gaskets.
REMOVING AND CLEANING THE STEEL BEATER
OPTIONAL
x
Pull the beater towards you to remove it from the
batch freezing cylinder.
x
Recover the seal gasket placed on the back of the
beater.
x
Remove the scrapers from the beater by pulling
firmly.
x
Place the previously disassembled components into
the tub with the sanitizer and brush the surfaces with
care. Pay particular attention to the surfaces of the
scrapers.
REMOVING AND CLEANING THE TANK BEATER
(
OPTIONAL
)
x
Pull the beater upwards to pull it out of the tub.
x
Turn the plastic impeller clockwise until it releases.
x
Emerge the previously disassembled components
into the tub with the sanitizer and brush the surfaces
with care. Pay special attention to the inner duct of
the beater shaft.
Summary of Contents for KISS 3 POWER Series
Page 47: ...ENGLISH 46 ...
