25 - ENGLISH
6.5 ADJUSTING THE TEXTURE
6.5.1 ADJUSTING THE TEXTURE DURING ICE CREAM PRODUCTION
If the consistency of the product is not
satisfactory, it is possible to change the value
directly from the push button control panel by
following the instructions below:
-
Make sure the machine is turned on, it
contains
enough
and
set
for
the
PRODUCTION of soft ice-cream.
-
At any time, to enter the mode to adjust the
texture, press and hold the PRODUCTION
and SET keys until the display shows the last
set of consistency programmed. The SET
LED turns on.
-
The LEDs of the UP (
Ÿ
),Conferma (Confirm)
(
ŻŹ
) and DOWN (
ź
) keys start flashing
and the numbers relative to the consistency
setting to be configured, expressed by a
numerical value between 60 and 250, appear
on the display: press the “UP (
Ÿ
)” and
“DOWN (
ź
)” keys to increase or decrease
this value.
Higher consistencies correspond to high
numbers, lower consistencies correspond to
low numbers.
The maximum programmable consistency
value is equal to 250 numbers but not all
mixtures can reach such a high consistency
value.
For mixtures particularly low in sugar and fat,
it is recommended to not select consistency
numbers close to 250.
-
Subsequently, press the Conferma (Confirm)
(
ŻŹ
) key to save the new consistency value
programmed.
Summary of Contents for KISS 3 POWER Series
Page 47: ...ENGLISH 46 ...
