Frigomat AGG.2014 Series, Use And Maintenance Manual

Page: 41 / 96

ENGLISH - 40
6.7 EXTRACTION
To extract the product at the end of a productive
cycle, refer to the following instructions:
- Position a cold and clean tub of adequate capacity
on the front shelf of the machine.
- Check that the production cycle has ended.
- Unscrew the plastic knob at the centre of the door
by about half a turn.
- Press the knob to detach the dispenser disk from
the door surface and subsequently pull it upwards.
- When the product starts coming out of the door
safety grid, press the EXTRACTION key to select
high speed and disable the compressor in order to
prevent ice from forming on the cylinder walls in the
emptying phase (Fig.1).
Mixtures with high content of sugar and fat, to
maintain the quality of the product unaltered during
the high speed extraction phase, it is recommended
to enable the “Cold extraction” function. To enable
this function one must press the EXTRACTION key
again when extraction has already begun.
With the “Cold extraction” function enabled the
display shows the message E-C (Fig.2).
- When all the product has come out of the door,
press the STOP key to stop the machine and re-
close the dispenser disk (Fig.3).
Fig.1
Fig.2
Fig.3