Fri-Jado Cold MCC, Service Manual

Page: 19 / 147

Rev 3 Service Manual MCC Hot / Cold 2021
Page 19
4.9 Connecting drain (Cold unit only)
During the installation process of the MCC Cold, a drain connection must be made.
Connect the drain of the unit, onto the main drain of the building using PVC piping
(not included).
If no drain connection can be made, an evaporation tray must be placed.
4.10 Installation of the evaporation tray (including specification)
1. Turn of unit, and pull power plug from wall outlet.
2. Open back panel of unit ( refer 11.16)
3. Extend drain of unit, using the delivered drain pipe.
Cut pipe on required length (depending on measurements of unit).
4. Put angle piece on end of drain pipe, exactly above the evaporator tray.
5. Place evaporation tray in position and mount this with two bolts and nuts
Evaporation tray must be placed with the serial number label faced to the back
of the unit. Label must remain visible (readable) (see drawing below)
6. Connect power cord of evaporator tray to outlet on electrical box of MCC unit.