Fri-Jado Cold MCC, Service Manual

Page: 15 / 147

Rev 3 Service Manual MCC Hot / Cold 2021
Page 15
4.0
Installation
Adjusting the hight of the doors
To adjust the doors in height after placement,
Loose the mounting screws of the hinge a little.
If loose, the glass can be moved slightly inside
the hinge assembly
4.10 Installation and positioning
WARNING
Cold units: The propane refrigerant is highly flammable.
All safety precautions must be followed.
WARNING
Position the unit on a flat and horizontal surface.
A temporally inclined plane of maximum 5° is allowed.
• Place the unit level on a sufficiently sturdy floor.
• Keep the weight of the unit in mind.
• Use a level-ling instrument to level the unit by adjusting the unit’s legs.
(Refer to next page)
• MCC cold: Please take notice of label with minimum space required
• Be sure that the personnel have sufficient room to work with the unit.
• Keep a distance of at least 150 mm (6 inch) between the back wall and the unit.
• Do not position a unit near a doorway, a ventilation device or a refrigerator in order
to avoid any negative effects on the unit’s operation by a cold airflow.
The unit is designed for a maximum draft of 0.2 m/s (0.65 ft./sec).
• Do not place the unit into direct sunlight.
• Be sure that the ambient temperature for cold models remains between
10 ºC - 25 ºC (50 ºF - 77 ºF) and that the relative air humidity remains below 60%.
Cold units have been designed to operate at climate class 3 (according ISO 23953).
• Hot units should not be used below 20 ºC (68 ºF) ambient temperatures.
• Keep the plinth free from any obstacles to ensure ventilation.