Fri-Jado Cold MCC, Service Manual

Page: 59 / 147

Rev 3 Service Manual MCC Hot / Cold 2021
Page 59
Lights & digital inputs ("Lit" folder)
dOd Enable utility switch-off on activation of door switch 0 num
dad Activation delay for digital input 0 min
dCO Compressor deactivation delay after door opened 0 min
dCd Fans activation delay after door closed 10 secs
Pressure switch ("Pre" folder)
Pen Number of errors allowed for general pressure switch input 5 num
PEI Minimum/maximum pressure switch error count interval 1 min
Pet Delay in activating compressor after pressure switch deactivation 0 min
Deep cooling ("dEC" folder)
dCA Enable deep cooling 0 num
dCS Deep cooling setpoint -1 °C
tdC Deep cooling duration 0 min
dcc Defrost delay after deep cooling 0 min
Sid Deep cooling start threshold 12 °C
toS Over-threshold time for deep cooling start 5 min
Energy saving ("EnS" folder)
Est Energy Saving mode 0 num
ESA AUX output status in energy saving mode 0 num
ESF Night mode activation for fans y flag
Cdt Door close time 60 min*10
ESo Cumulative door open time for disabling Energy Saving mode 0 num
OSP Offset on setpoint 0,5 °C
OdF Intervention differential correction 4 °C
dnt Duration of night mode 10 hours
dFt Duration of fast cooling mode 1 hours
SPn Night mode setpoint 1 °C
dFn Night mode offset 2 °C
SPF Fast cooling setpoint -1 °C
dFF Fast cooling offset 0,1 °C
ESP Virtual door regulator's sensitivity 0 num
dOt Maximum Time Door Open with virtual door switch 0 secs
Communication ("Add" folder)
PtS Communication protocol selection t flag
dEA Device address 0 num
FAA Family address 0 num
Pty Modbus parity bit setting n num
StP Modbus stop bit setting 1b flag
Display ("dIS" folder)
LOC LOCk Setpoint change shutdown n flag
PS1 Password 1 0 num
PS2 Password 2 0 num
ndt Display with decimal point y num
CA1 Calibration 1 (Pb1) 4,8 °C
CA2 Calibration 2 (Pb2) 0 °C
CA3 Calibration 3 (Pb3) 0 °C
ddL Display mode during defrost 2 num
Ldd Timeout value for display unlick 15 min
9.2
Parameter MCC Cold Settings (Full Serve)