Problem 9 - The steam assembly and/or wand is leaking.
Solution 1 - Rebuild the steam assembly.
1. Remove the machines
top panel and turn the ball
valve off on the appropriate
steam assembly.
3. Using the flat side of
a foam knife, unscrew
the steam knob bezel.
4. Remove the bezel
from the knob.
5. Remove the cotter pin us-
ing diagonal cutters.
6. Place one hand under
the knob as you unscrew it
to catch the two washers.
7. Loosen the steam tube
nut using a 17mm wrench
and unseat the tube from
the assembly.
8. Remove the steam assembly
mounting nut using a 26mm
wrench. NOTE! Use care not to
scratch the facia.
9. Remove the steam
assembly from the
machine.
10. Compress the washer and
spring against the valve body and
remove the snap ring using a pair
of snap ring pliers.
11. Remove the valve body
from the shaft using 24 and
26 mm wrenches.
12. Pull the shaft from
the body.
2. Turn off the steam supply ball
valve and open the steam knob to
relieve pressure in the tube.
