- 317 -
7.15.1.2 show interface switchport protected
This command displays the status of the interface (protected/unprotected) under the groupid.
Syntax
show interface switchport protected <slot/port> <groupid>
Default Setting
None
Command Mode
Privileged Exec
Display Message
Name:
An name of the protected port group.
Protected:
Indicates whether the interface is protected or not. It shows TRUE or FALSE. If the group
is a multiple groups then it shows TRUE in Group <groupid>.
7.15.2 Configuration Commands
7.15.2.1 switchport protected
This command used to modify a protected port group name. The <groupid> parameter identifies the set
of protected ports. Use the name <name> pair to assign a name to the protected port group. The name
can be up to 32 alphanumeric characters long, including blanks. The default is blank.
!
Port protection occurs within a single switch. Protected port configuration does not affect
traffic between ports on two different switches. No traffic forwarding is possible between
two protected ports.
Syntax
switchport protected <0-2> name <name>
no switchport protected <0-2> name
<name> -
Assigns a name to the protected port group.
no -
Remove a name from the protected port group.
