- 292 -
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interface:
Specifies the list of all the ports on which LLDP-MED is enabled.
Remote ID:
An internal identifier to the switch to mark each remote device to the system.
Device Class:
Specifies local device's MED Classification. There are four different kinds of devices,
three of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP Telephone
etc.]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router,
IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.
7.12.1.12 show lldp med remote-device detail
The user can go to the CLI Privilege Exec to d
display detailed information about remote devices that
transmit current LLDP-MED data to an interface on the system, use the
show lldp med remote-device
detail
<slot/port>
Privilege command.
Syntax
show lldp med remote-device detail <slot/port>
Default Setting
None
Command Mode
Privileged Exec
Display Message
Term Definition:
Capabilities
: Specifies the supported and enabled capabilities that was received in MED TLV on
this port.
MED Capabilities Supported
: Specifies supported capabilities that was received in MED TLV
on this port.
MED Capabilities Enabled:
Specifies enabled capabilities that was received in MED TLV on
this port.
Device Class
: Specifies device class as advertised by the device remotely connected to the
port.
Network Policies
Specifies if network policy TLV is received in the LLDP frames on this port.
