Foma N900i '04.2, Manual

Page: 95 / 388

93
Making/Receiving Videophone Calls
● You cannot take a videophone call by the “Any key answer” function even when the “Answer setting”
(p.159) is set to “Any key answer”. (If “Answer setting” is set to “Quick silent”, pressing any key stops
the ring tone only.)
● Even while a substitute image is displayed during a videophone call, the digital communication charge
is charged to the videophone caller.
● You can change a substitute image in the “Select image” (p.98).
● Even if the “Voice mail” service is “Activate”, an incoming videophone call cannot be connected to the
voice mail service center. An incoming videophone call is continued.
● Even if “Call forwarding” service is “Activate”, an incoming videophone call cannot be forwarded unless
the destination is a videophone-support device that conforms to 3G-324 (p.87). Make sure the
forwarding destination before making the forward setting. The videophone caller cannot view the
guidance for forwarding calls.
● When no image is sent to your FOMA terminal due to the other party’s setting, a substitute image is
displayed.
● You cannot switch to the handsfree operation while receiving a videophone call.
● Ending a videophone call turns the handsfree operation OFF.
●
You can adjust the “Volume” (p.78) during the handfree operation.
● When the earphone/microphone with switch is connected, you can answer a videophone call with the
camera view by pressing
e
or with a substitute image by pressing
r
as same as the case with
no earphone connected.
3
When you finish the conversation, press
y
.
The call duration appears, and then the videophone call ends.
2
After the videophone call is connected, press
o
to
switch to the handsfree mode.
“ ” appears and you can hear the voice of the other party over the speaker. When you press
o
[ ] again, the handsfree mode is turned off and “ ” changes to “ ”.
The voice of the other party can be heard around your FOMA. Choose the place where the
sound does not bother other people to use the handsfree mode.
To send the out-camera view
Press
d
[Change].
Pressing
d
[Change] switches between the in-camera and out-camera (Camera Switch).
To put a videophone call on hold
Press
t
.
The other party can hear the hold tone and view the “Holding” image on the videophone
display of one’s terminal. To cancel putting on hold, press
t
.
To answer an on-hold videophone call with a camera view, press
e
. To answer with a
substitute image, press
r
.
When using an earphone/microphone with switch (optional)
You do not have to switch to the Handsfree mode. You can hear the voice of the other party
over the earphone.
Receiving a Videophone Call