Website
21
7.4.1 Bind Setting
7.4.2 Custom Port Protocol
7.4.3 Failsafe
1. E
nter the
Custom port protocol
menu
.
2. C
lick the Newport you want to set, such as
NPA
. Then click
an appropriate protocol.
3. Tap to return.
Notes:
1. For multi-receiver mode as well as the
S-tele
is selected, you
can set protocol separately for
Primary
receiver and
Secondary
receiver.
2. The signal types that can be selected once only in multiple
for any Newport:
PPM
,
S.BUS
,
i-BUS-IN
and
i-BUS-OUT
. If it is
selected for
NPA
,
i-BUS-OUT
cannot be selected again for
NPD,
NPC or NPB
.
3. For the receivers with SENS interfaces,
i-BUS/Servo
does not
support
i-BUS-IN
.
7.4 RX Setup
Used to let the transmitter into binding state, so as to bind
with the receiver.
For specific binding instructions, please refer to
5.2 Binding
.
Sets the type of output signal of the receiver interface. This
screen shows on the left side the interfaces that can be set,
and on the right side, the protocols that can be set.
Function Settings:
For failsafe function, paladin PL18 EV transmitter provides
the following three settings:
•
Set to disable the signal output of i-BUS-out and PPM
protocol interfaces in case of out-of-control, i.e., no
output at i-BUS-out & PPM interfaces in case of losing
control.
•
Set failsafe values channel by channel:
No output
/
Fixed
value
/
Hold
.
This section is an introduction to receiver functions.
The menu of enhanced receivers
The menu of classic receivers
The menu of multi-receiver