Website
35
7.10 Trims
You can view the trim values that assigned functions. For TR1 to TR8, you can set the appropriate
Step value
,
Trim
mode
and
Trim value
, whether for current condition or all condition. And for VR
kind
traim, you can only set the
Trim mode and Trim rate.
7.11 Func. Rate(AFR)
You can set servo volume change curves of all sticks, knobs, and switches assigned to the channel. You can switch
to different conditions to set different curves respectively. The servo volume change curve for the conditions
controlled by DR is set after enabling the DR. It is recommended that the Func. rate be set after the End point
setting is finished. Any mixes source will be applied the Func. rate function.
Function Settings:
1. Enter
Trim
menu.
2. Toggle the corresponding trim button on the transmitter
for adjustment. Toggle the trim key. The current channel
change value is the step value. Hold the trim key for
seconds to quickly change the value.
3. Adjust until the model posture is balanced. Release the
button to finish the adjustment.
Different trim modes can be selected under different trim
buttons, mainly including
Translation
(the trim value is
limited by the range of channel travel, the size of the trim
value within the range does not change with the channel
value),
Center max
(Maximum at the midpoint, positive
and negative respectively weakened to the maximum/
minimum value of travel when the trim is 0),
High max
(The highest point of travel is the normal value of trim, go
to the low end with the trim weakened, the other is similar
to horizontal movement), and
Low max
(Opposite of
High
max
).
RateA
is the ratio to the left of the neutral, and vice versa
for
RateB
.
EXPA
is the curve to the left of the neutral, and
vice versa for
EXPB
.
Rate A/B
and
EXPA/B
are selected
separately or fully depending on the curve type, when the
curve type is
EXP1
,
EXP1
can not be adjusted separately
although it distinguishes between A and B. When the curve
type is
EXP2, SYMM
(symmetric), the rate and curve are
divided into A and B. A and B need to be set in linkage, and
cannot be adjusted individually. When the curve type is
EXP2, LINE
, the rate and curve are divided into A and B,
and both A and B can be adjusted separately
Note: This function is mainly used in the process of model operation.
Please remember operation steps before you start to use it.
Note: This function is available for version 1.0.28 or above.
