Flybox Eclipse, Installation And Operating Manual

Page: 30 / 72

Vne
(Velocity Never Exceed)
Vno
(Velocity Normal Operation)
Vfe
(Velocity with Flaps Extended)
Vs
(Velocity of the Stall)
Vs0
(Velocity Stall 0)
NOTE
: If you prefer the clean transition from white to green zone set the same value on Vs and Vfe.
•
ALT GAUGE SETUP
VSI max :
Set the maximum value for the vertical speed indicator.
Altimeter unit :
Set the unit of measure for the altimeter in meters (Mt) or feets (Ft). The unit of measure for VSI change
accordingly in meters per second or feets per minute.
Pressure unit
: Set the unit of measure for pressure reference in milliBAR (mBAR) or inches of mercury (inHg).
6.1.3 Fuel computer setup menu
Min quantity warning :
Set the amount of fuel below which is activated the corresponding alarm.
Min time warning :
Set the time to empthy below which is activated the corresponding alarm.
Balance warning :
This function is useful to keep balanced two wing tanks, switching from one to the other after using a certain
quantity of fuel. If the “Balance” alarm are enabled, Eclipse will activate an alarm every time the quantity of fuel used equals this
value, showing “TANK BALANCE” on the display. To disable this function set the value to zero.
Tank capacity :
Set the tank capacity (if there are more than one tank set the total capacity of the tanks).
K factor :
Set the fuel flow transducer's K-factor (K-factor of a fuel flow transducer is the number of electric pulses for 1 gallon of
fuel consumption).
K Factor auto-calibration
: Refer to chapter 7.2 “Fuel flow transducer calibration”.
NOTE:
It's recommended to execute the K
factor calibration as soon as possible to have the maximum accuracy in fuel flow measurements.
Space unit
: Set the unit of measure in kilometers (Km) or nautical miles (NM).
Ext. GPS for reserve indication :
Select “YES” if you have connected an external GPS with “Goto” or “Flight plane” function to
enable the “RESERVE” indication on the fuel computer section and to enable the NAV autopilot function.
Select “NO” if you have not connected any external GPS (apart from the Flybox® GPS furnished with the ECLIPSE).
External GPS baud rate
: Set the baud rate of the external GPS.
Fuel computer enable :
YES/NO. Enable or disable the fuel computer section display (only for EIS or IFIS ECLIPSE).
30
Vne
Vno
Vfe
Vs
Vs0