Fluke 5820A, Operator'S Manual

Page: 42 / 272

5820A
Operators Manual
3-4
0 •
1 2 3
4 5 6
7 8 9
ENTER
k sec
m
µ V
NEW
REF
Hz
FIELD
EDIT
/
+
VOLT EDGE LEVSINE MARKER
MENU
PREV
M
RESET
SETUP
CE
MODES
MORE
CHAN
dBm
n
MULT
x
DIV
÷
INPUT
AUX
OPR
STBY
3
9
4 5
6 7
8
2
1
I
O
CHAN 2
CHAN 4
EXT TRIG
EXT TRIG
SOURCE/MEASURE
CHAN 1 CHAN 2
CHAN 3 CHAN 4
CHAN 5
20V PK
MAX
CHAN 1-5
AUX
INPUT
20V PK
MAX
20V PK
MAX
CAT
130V
PK
MAX
SOURCE
30V DC
MAX
MEASURE
5820A OSCILLOSCOPE
CALIBRATOR • 2GHz
yh004f.eps
Figure 3-1. Front Panel View
Table 3-1. Front Panel Features
A
Output Display
The Output Display is a two-line backlit LCD that shows output amplitudes, frequency and
calibrator status. Output values (or potential output values if in standby) display using up to
seven digits plus a polarity sign. Output frequencies (or potential output frequencies if the
5820A is in standby) display using four digits. Calibrator status is indicated by displaying the
following abbreviations:
OPR Displayed when an output is active at the front panel terminals or auxiliary
amplifier terminals.
SBY Displayed when the 5820A is in standby.
ADDR Displayed when the 5820A is addressed over the IEEE-488 interface.
u When you change the output, a “u” (unsettled) displays for a second or
two until the output settles to within the specified accuracy.
m Displayed when the calibrator is making a measurement.
? Displayed when the amplitude is specified as typical only, and/or reduced
resolution. This occurs when operating the 5820A in the extended
bandwidth mode.
Cx Shows which channel is selected if the 5-channel option is installed. The
channel is indicated by a “C” in the lower right corner of the output
display.