Fluke 5820A, Operator'S Manual

Page: 148 / 272

5820A
Operators Manual
6-6
Table 6-1. Command Summary by Function (cont.)
RS-232 Host Port Commands
LOCAL Puts the 5820A into the local state.
LOCKOUT Puts the 5820A into the lockout state. This command duplicates the IEEE-488 LLO
(Local Lockout) message.
REMOTE Puts the 5820A into the remote state. This command duplicates the IEEE-488 REN
(Remote Enable) message.
SPLSTR Sets the serial remote mode Serial Poll response string.
SPLSTR? Returns the string programmed for serial remote mode Serial Poll responses.
SRQSTR Sets the serial remote mode SRQ (Service Request) response (up to 40 characters).
SRQSTR? Returns the string programmed for Serial Mode SRQ response.
^P (<cntl>p) Control-P character prints the serial poll string. (See SPLSTR for string format.)
^C (<cntl>c) Control-C character clears the device.
^T (<cntl>t) Control-T character executes a group trigger.
Setup and Utility Commands
FORMAT Use with extreme care. Restores the contents of the nonvolatile memory device to
factory defaults.
ONTIME? Returns the time since the 5820A was powered up last.
PR_RPT
Prints the Stored, Active, or CAL_Report through either the HOST or the UUT Serial
Port.
SP_SET Sets the RS-232-C serial port settings and saves them in nonvolatile memory. The
settings apply only to HOST port.
SP_SET? Returns the HOST serial port settings contained in nonvolatile memory.
TLIMIT_D Sets the default OPERATE time limit for the OVERLD mode signal.
TLIMIT_D? Returns the default overload time limit.
ERR_UNIT Chooses how the UUT error is shown.
ERR_UNIT? Returns presently selected values of ERR_UNIT.