Fluke 522A/6, Operator'S Manual

Page: 24 / 426

5522A
Operators Manual
1-4
•
10 MHz reference input and output. Use this to input a high-accuracy 10 MHz
reference to transfer the frequency accuracy to the 5522A, or to synchronize one or
more additional Calibrators to a master 5522A.
•
Simultaneous output of two voltages.
•
Extended bandwidth mode outputs multiple waveforms down to 0.01 Hz, and sine
waves to 2 MHz.
•
Variable phase signal output.
•
Standard IEEE-488 (GPIB) interface, complying with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
•
EIA Standard RS-232 serial data interface for printing, displaying, or transferring
internally stored calibration constants, and for remote control of the 5522A.
•
Pass-through RS-232 serial data interface for communicating with the Unit Under
Test (UUT).
Safety Information
This Calibrator complies with:
•
ANSI/ISA-61010-1 (82.02.01)
•
CAN/CSA C22.2 No. 61010-1-04
•
ANSI/UL 61010-1:2004
•
EN 61010-1:2001
In this manual, a Warning identifies conditions and actions that pose hazards to the user.
A Caution identifies conditions and actions that may damage the Calibrator or the
equipment under test.
Symbols used in this manual and on the Product are explained in Table 1.
Table 1-1. Symbols
Symbol Description Symbol Description
CAT I
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified
by terminal markings.

Conforms to relevant North American
Safety Standards.

Conforms to European Union
directives

Do not dispose of this product as unsorted
municipal waste. Go to Fluke’s website for
recycling information.

Risk of Danger. Important information.
See manual.

Hazardous voltage

Earth ground

Conforms to relevant Australian EMC
requirements

Warning
To prevent personal injury:
•
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
To prevent possible electrical shock, fire, or personal injury: