34 |
www.flowair.com
2.6.
Inlet and exhaust covers installation (not applicable to the Cube 40 unit)
Covers for Inlet and outlet channels prevent mixing of ventilation air mixing and protect against rain or snow getting into the
unit. The covers are delivered inside the unit under the panels on inspection side. This is also the place where screws are located .
See below drawings and install the covers properly.
•
Connection must be done with the blind rivets. Do not use screws witch might loosen doe to vibration.
•
Protection covers in Cube 50/60 must be fastened with supplied bolts.
•
The covers should be screwed to the device using the mounting screws included in the set.
