FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 81 / 146

75 September 6, 2017
Configuration and Operation
CM-6212 H1-I User and Installation Guide
Manual Trigger
Select Off or On to activate this function. The default is Off .
Triggered Action
Specify one or both alarms to trigger:
·
Enable alarm output – Check this box and select the predefined type of alarm output (high or low)
to enable alarm relay when an alarm is triggered.
·
Send Message by FTP – The Administrator can select whether to send an alarm message by FTP
when an alarm is triggered.
·
Upload Image by FTP – Selecting this option enables you to assign an FTP site and configure
various parameters.
·
Send HTTP notification – Check this option, select the destination HTTP address, and specify the
parameters for HTTP notifications.
·
IR Cut Filter – Select this checkbox to trigger an event when the IR cut filter is activated. From the
drop-down menu, select on or off. When the IR Cut filter is set to on, the IR LED illuminator is
activated for use in low-light environments in which Night mode is normally used.
·
Send message by E-Mail – The Administrator can select whether to send an alarm message by e-
mail when an alarm is triggered.
·
Upload Image by E-Mail – Selecting this option enables you to assign an e-mail address and
configure various parameters.
·
Record video clip – Select this box in order to save the alarm-triggered recording into a microSDXC
card.
File Name
·
File Name – Enter a file name in the field, for example image.jpg. The uploaded image’s file name
format is set in this section. Select one that meets your requirements.
·
Add date/time suffix (default setting)
File name: imageYYMMDD_HHNNSS_XX.jpg
Y: Year, M: Month, D: Day
H: Hour, N: Minute, S: Second
X: Sequence Number
·
Add sequence number suffix (no maximum value)
File name: imageXXXXXXX.jpg
X: Sequence Number
·
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix ends at the number being set. For example, if the setting is up to “10,” the file
name will start from 00, end at 10, and then start over again.
·
Overwrite
The original image in the FTP site will be overwritten by the new uploaded file with a static
filename.
Click SAVE after configuring the settings.