FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 78 / 146

September 6, 2017 72
Configuration and Operation
CM-6212 H1-I User and Installation Guide
·
Add sequence number suffix (limited value)
File Name: imageXX.jpg
X: Sequence Number
The file name suffix ends at the number being set. For example, if the setting is up to “10,” the file
name will start from 00, end at 10, and then start over again.
·
Overwrite
The original image in the FTP site will be overwritten by the new uploaded file with a static
filename.
Click SAVE after configuring the settings.
9.3.4.4 Day/Night Trigger
The Day/Night Trigger screen is used to enable the camera to trigger a device connected to the camera’s
alarm output when the camera switches to Day or Night mode, which is set on the IR Function screen.
Day/Night Trigger Screen
To configure the day/night trigger
1. In the Day/Night Trigger section, select On to enable the Day/Night Trigger or Off to disable it.
2. In the Day/Night Type section, select Day when the camera enters Day mode, for example to
deactivate an external device, such as a lighting source. Select Night to activate an external device
when the camera enters Night mode.
3. In the Triggered Action section, check Enable alarm output to activate an external lighting source.
Depending on the voltage requirements of the external device, from the drop-down menu select
high or low .