FLIR identiFINDER R200, Manual

Page: 48 / 130

Service
Menu Definitions
The factory default is "left, up, right, left, up, right,
left"
( , , , , , , ).
Status
Displays system status, including Serial Number (S:), ID,
Firmware Build, and available memory.
This information will prove useful in the event that
the FLIR detection service department must be
contacted to assist with any concerns in the
operation of the FLIR identiFINDER R200.
Before calling, pull up this screen and either copy the the information; or, perform a
screen capture (briefly press the "Power" the "Left" button and usethe image
which is stored on the Mass Storage device in the folder "Screens"). An advantage to
the screen capture is that it can be stored in a separate place from the detector where
it can be accessed should access to mass storage on the R200 be unavailable. It
may then be used to either read to, or e-mail the information to a service rep-
resentative to be used in diagnostics.
BT Log (Bluetooth)
Set "BT Log" (bluetooth logging) to "On", or "Off".
This log is is only required if the user has any
concerns with Bluetooth connectivity and provides
diagnostic information for service technicians.
"Service" Menu(continued)
R200 3/10/2017 __ 1:38 PM 2–41