O P E R A T I O N
C H A P T E R 6
Figure 154: MixW Serial Port Details
5. Set the
Port
to
COM16
,
RTS
to
CW
and
DTR
to
PTT.
Click OK on this form and the previous
form.
6. Change the mode in MixW to CW. Click on the
TX
button on MixW’s main panel. It should key
PowerSDR without generating a tone. Click
RX
in MixW and PowerSDR should return to receive.
If you have entered your callsign in MixW, click on the
CQ
button. It should key the radio and
produce Morse code calling CQ with your call sign. Verify with the
TX Meter (4)
set to
Fwd
Pwr
that there is forward power.
7. You are now ready to begin a QSO. If a 50 ohm dummy load was connected, connect an
antenna in its place. Tune to the desired frequency using one of the methods outlined in the
Tuning Methods section above. Select either
CWL
or
CWU (6)
and proceed with the QSO.
[The rest of this page has been left blank intentionally]
171
2003-2008 FlexRadio Systems
