O P E R A T I O N
C H A P T E R 6
Figure 172: MixW Serial Port Settings
Recall that we are using the COM6-COM16 virtual COM port pair and that we setup PowerSDR to
connect to the COM6 end of this pair (see the CAT Control Setup section above). We therefore now
select
COM16
as the
Port
in the form above. Set the
Baud rate
to
115200
(it makes no difference
what you set this to).
For
RTS
and
DTR
we need to match the settings on the PowerSDR Setup Form, Keyer Sub-Tab.
Therefore set
RTS
to
CW
and
DTR
to
PTT
as shown above. Click
OK
on this form and then on the
PTT & CAT
form respectively to accept the settings and close the forms.
On the MixW front console, click again on
Configure
on the menu bar and this time select
Sound
device settings…
to open the following form (Figure 173):
[The rest of this page has been left blank intentionally]
190
2003-2008 FlexRadio Systems
