F R O N T C O N S O L E
C H A P T E R 3
(6 and 6b) Mode Selection
Figure 39: Primary (left) and RX2 (right) Mode Selection
The Mode Selection controls allow you to change the selected demodulation routine. Changing modes
will select the last frequency and filter used for that mode. Additionally, it will display the (configurable)
filter settings available for that mode (see Figure 41 below) as well as display the appropriate mode
specific controls on the front console (see page 59). Following is a list of the available modes:
LSB:
Lower Side Band
USB:
Upper Side Band
DSB:
Double Side Band
CWL:
CW
L
ower Side Band
CWU:
CW
U
pper Side Band
FMN:
Frequency Modulation (FM) Narrow
AM:
A
mplitude
M
odulation
SAM:
S
ynchronous (PLL)
A
mplitude
M
odulation
SPEC (RX1 only):
Spec
trum mode (DC IF, max bandwidth determined by the selected
sampling rate)
DIGL:
Dig
ital
L
ower Side Band (Enables VAC if VAC Auto Enable is engaged, see page 93)
DIGU:
Dig
ital
U
pper Side Band (Enables VAC if VAC Auto Enable is engaged, see page 93)
DRM:
D
igital
R
adio
M
ondiale (requires licensed external demodulator software not available
from FlexRadio Systems; Enables VAC if VAC Auto Enable is engaged, see page 93)
Hotkeys are available in the Setup-Form, Keyboard Tab to cycle through the various modes using the
keyboard (see page 123).
[The rest of this page has been left blank intentionally]
56
2003-2008 FlexRadio Systems
