U P D A T I N G T H E F L E X - 5 0 0 0 F I R M W A R E
A P P E N D I X B
Update the Firmware
To update the firmware, power-up the FLEX-5000, make sure it is communicating with your computer.
You can verify this by successfully opening the FLEX-5000 Driver Control Panel. Close this Control Panel
if you opened it.
Next, locate the batch file labeled
Burn.bat
in the firmware folder (the same folder containing the
ReadMe file) and double-click on it to open the window shown in Figure 184 below.
Press any key to continue and you will subsequently receive the message
Uploading Binary
, followed
by
Deleting Flash Image
and then
Programming Flash Image
, each preceded by a progress
counter. When the upgrade is completed successfully you will hear the relays click and see the screen
shown in Figure 185 below.
[The rest of this page has been left blank intentionally]
208
2003-2008 FlexRadio Systems
Figure 184: Burn.bat Initial Screen