FlexiForce ForceIQ Force100XC, Manual

Page: 6 / 42

manual – force IQ
6
www.flexiforce.com
6
2.4. Assembling the drive unit
The door must be correctly installed, balanced and be in closed position before the assembly of the operator.
For the operator a mounting attachment of >500N is required.
1. Attach the first stop ring to the shaft.
2. Attach the wall bracket with 4 screws and washers to the motor.
3. Push the operator completely against the stop ring.
4. Mount the wall bracket to the wall with two suitable screws and washers.
Per mounting attachment >500N is required.
5.
Disengage the drive unit from the door shaft by moving the handle clockwise until it stops,
then aim for the keyways at the door shaft and the operator. *The wedge should protrude a
few mm from the wall bracket.
6. Attach the second stop ring. A gap of a few mm should remain between the stop ring and
the wall bracket.
7. Tighten all screws.
8. Route the cable down to the control unit.