FlexiForce ForceIQ Force100XC, Manual

Page: 16 / 42

manual – force IQ
16
www.flexiforce.com
16
3.4.3. Adjusting the end position
Warning:
Risk of material damage: The door could be moved beyond the upper and lower end position manually during
installation ( in hold to run mode). This may result in damage to the door.
Observe the door during setting the end positions permanently.
Before adjusting the end position: Place the door in the middle position. Check if the door goes up when the
button is pushed. If the door does not go up then change the direction of the motor. (See page 12 "Motor
direction")
Use the or buttons to select one of the following menu items:
1) Top
2) Bottom
3) Brake offset
4) Fine pitch up
5) Fine pitch down
6) Pre end position
7) Safety limit
8) Pos med speed
Press to enter the selected menu item.
1) Top: Run the door in the desired position using or
.
press to confirm end position.
Check if the counter counts up when the door goes up. If the counter doesn't count up, change the
direction of the encoder. (See paragraph "Motor setup").
Use the and button to select the bottom adjustment.
2) Bottom : Run the door in the desired position using or . Press to confirm the end position.
Function control: Test the safety edge setting by using a 30x50mm gauge block. Run down the door to the
50mm side of the block, and the door must reverse up again. Run down to the 30mm side of the block,
and the door must stop. You can adjust the height of the limit with point 6 "pre‐end position"
3)
Brake offset: Use the buttons to adjust this position.
Can be used for heavy and light doors. See for
more info next page.
4) Fine pitch up : If needed, use the buttons to define the exact top end position of the door
5) Fine pitch down : If needed, use the buttons to define the exact bottom end position of the
door.