FlexiForce ForceIQ Force100XC, Manual

Page: 29 / 42

manual – force IQ
29
www.flexiforce.com
29
4.5. Photocells
(
for example we use the OS‐IR)
Connect the photocells as below
OS‐IR ForceIQ KL4 ForceIQ KL5
Brown
(transmitter)
4 1
Brown
(receiver)
3 1
Blue (
both)
1 4
yellow 2 3
black 1 1
See also basic wiring diagram
Photocell 1, terminal KL5:
•
Use the or arrow to navigate to the "Safety devices" menu. Press to enter the menu.
•
Use the or arrow to select "4‐wire photocell disabled". Press to enter the menu.
•
Use the or arrow to select "Untested". Press to confirm.
•
Use the or arrow to navigate to
"Down full reverse".
Press to confirm.
•
Press the arrow twice to enter the maneuvering mode
Photocell 2, terminal KL4 :
•
Use the or arrow to navigate to the
"Safety devices"
menu. Press to enter the menu.
•
Use the or arrow to select
"OSE 2 setup KL4".
Press to enter the menu
•
Use the or arrow to select "4‐W photoc. KL4 ". Press to confirm.
•
Use the or arrow to navigate to "Down full reverse". Press .
•
Press the arrow twice to enter the maneuvering mode.
Switch off photocell 1 function at installed position of the optics
:
This function will enable you to switch the photocell ON or OFF.
•
Use the or arrow to navigate to the "Safety devices" menu. Press to enter the menu.
•
Use the or arrow to select "4‐wire photocell disabled". Press to enter the menu.
•
Use the or arrow to select "
Untested
". Press to confirm.
•
Use the or arrow to navigate to " Down full / sw off ". Press to confirm.
•
Use or to adjust to the desired position were the photocell has to switch off.
•
Press 2x to confirm
•
Press 2x to return to the maneuvering mode.
With the forceIQ two kits are possible
It is not possible to switch off photocell 2 at the installed position of the optics