FlavorShot AC-FS5, Service Manual

Page: 23 / 56

23
SECTION II – SERVICE TRAINING
1. Legs – See Plug & Play Installation – Section 1, page 6
To Install Legs:
1. Position the dispenser box with the “This Side Up” arrow pointing upward.
2. Turn the dispenser box on its side.
3. Remove the packaging material at the bottom.
4. Remove the legs from the box.
Check the adjustable bottom section of each leg, to ensure that it is screwed
snugly into the upper section of the leg. Tighten by hand until snug.
5. Install legs by screwing the top of each leg into the bottom of the dispenser.
Tighten by hand until snug.
6. Place the dispenser on a level surface or level the dispenser by adjusting the
legs by turning them slightly. To ensure the dispenser is level, place a
bubble level on the top of the dispenser during any adjustments. Ensure the
dispenser is level or slightly higher in the back. Do not allow the dispenser to
be tilted backwards.
NOTE:
•
After Installation of the legs, do not remove the legs from the dispenser or
allow the dispenser to sit flat on the counter.
•
Make sure all 4 of the adjustable 4-inch legs are in place at the four
corners of the bottom of the dispenser. These legs are adjustable and
they are secure even though they may appear to be loose.
•
Removal of the legs automatically voids the Warranty.
Install Legs