FlavorShot AC-FS5, Service Manual

Page: 11 / 56

11
If you refill the tank to the “Low” level:
a. Press the Flavor button for the tank filled
b. Press the Reset button.
The LCD will display “Reset - Full” or “Reset - Low Fill”.
Press the Reset button until “Reset - Low Fill” is displayed.
CAUTION: The accuracy of the low-level indicator and subsequent
lockout depend on filling the tank to the level indicated in the LCD
message.
If you accidentally select the wrong level, continue to press the Reset
button until the desired level appears in the LCD.
4. Replace tank cap. Twist until tight, to prevent spill.
5. Gently slide the tank shelf back into place.
6. Close the dispenser door.
TO RESET:
1. Close the dispenser door.
2. Press the
Flavor selection button for the tank that was filled.
3. Press the Reset button on the upper front of the dispenser.
CAUTION: Always Reset the tank after refilling, to ensure accurate
countdown to the low-level indication.
TO REMOVE AN EMPTY FLAVOR TANK
1. Place a container under the product dispensing block to catch any
residual flavor and to prevent spills.
2. Press the
Flavor button for the tank to be removed
3. Before the red light on the Flavor button goes out, press and hold the
Clean button for two seconds.
Allow the pump system to empty all residual product.
4. When the tank and pump are empty, press the Clean button again to
cancel the remainder of the clean cycle.
5. Open the dispenser door and slide the tank shelf forward.
6. Lift up the empty flavor tank out of the pump body and remove the tank.
7. Rinse, wash, rinse and sanitize the flavor tank. Follow Cleaning
instructions on page 17.
8. Load a clean, sanitized tank, following Install and Fill instructions on
pages 8, 9.
NOTE:
Always
clean empty tanks before re-using or storing them.
Follow the “Install, Fill & Prime Flavor Tanks” instructions on pages 8, 9 when
you place an empty tank in the dispenser.