FlavorShot AC-FS5, Service Manual

Page: 18 / 56

18
CLEANING: Individual FlavorShot tank, cap, and pump system
Step Action
1 Place a catch container under the product dispensing block
to catch any residual flavor from the tank and pump.
2 Press the Flavor button for the tank you wish to clean
3 Before the red light on the Flavor button goes out, press and
hold the Clean button for two seconds. The Clean button is
at the bottom of the Button Panel.
4 Allow the product in the system to drain completely.
5 Press the Clean button a second time to stop the cycle.
6 Discard the flavor.
7 Slide the tank shelf forward and lift the tank vertically to remove
it from the pump.
8 Clean the tank and the tank cap, following instructions on page
17.
9 Install a clean tank (cleaned as above) in the dispenser by
sliding the shelf forward and inserting the tank vertically into the
appropriate location on the tank pump shelf.
Before installing the tank, apply a small amount of food-grade
lubricant to the O-ring on the outlet at the bottom of the tank.
10 RINSE: Fill the tank with lukewarm water.
Press the
Flavor button for the tank to be cleaned.
Before the red light on the Flavo r button goes out,
press and hold the Clean button for two seconds.
Allow the water in the tank and pump to run out.
11 WASH: Fill the tank with a general purpose cleaning solution
as recommended by your detergent supplier, at 150 °F
or 65 °C.
Always fill to the “Full” line at the top of the tank.
Never wash with less than a full tank of cleaner. Do
not over-fill.
Press the
Flavor button for the tank to be cleaned.
Before the red light on the Flavor button goes out,
press and hold the Clean button for two seconds
Allow the cleaning solution in the tank and pump
system to run out. Make sure
all of the cleaning
solution runs out.
During the wash cycle, use a small brush to clean
the product dispensing block.