flamco Vacumat Eco 300, Installation And Operating Instructions Manual

Page: 15 / 388

TemplateA4_v20130506
ENG
15
5.5.5 Label from the terminal board cover (inside)
31 32 33 34 35 36 37
1 3 6 7 8 9 10 11
+24V
counter
signal
-
analog IN
sensor
SPC m1/V1.0
45 46 48 49 51 52
N
16 17 22 23 25 26
N L
~
N L
signal in
mains supply
230V 50/60Hz
44 47 50
PE
15 21 24
PE PE
extr
a - lo
w v
olta
ge
Terminal
42 43
N L
41
PE
19 20 18 12 13 14
38 39 40
fault
NC NO
2 4 5
27 28 29 30
+24V /
Read the manual !
Bedienanweisung lesen !
+24V /
signal
-
GND
INPUT
FC OUT
OUT + OUT
-
4 - 20 mA
refill IN 230V FU/ FC
level
switch
pressure
switch
refill release
FC
5A
5A
30
250
VDC
VAC
ohmic load
Stör
ung
FU
Standby
GND
sensor sensor
ATTENTION:
Even if unit is isolated from
power supply, terminals 12,
13, 14, 16 and 17 may carry
230V voltage!
ACHTUNG:
Trotz Netztrennung kann, an
den Klemmen: 12, 13, 14, 16
und 17 eine Spannung von
230V anliegen !
FC
M
fault FC
system
temperature
pwm
pressure
vessel
pressure
analog
out
0 - 10 V
OUT
analog
out
motor ball valve
high v
olta
ge
(230V 50/60Hz)
option
L
RS232
option
11.06.2015
option
option
GND GND GND GND
GND
A
A
GND
Klemmenplan Vacumat ECO 20150708
Explanation of the abbreviations on the label on the terminal board cover.
Note: The switch settings shown represent the current-free, non-switched state.
FU/FC
Frequency converter
refill IN 230V Top-up signal input 230V
extra-low voltage Protective low voltage
fault Fault, common fault output
M Motor (pump motor)
high voltage Voltage as per markings
L Phase
N Neutral wire
PE Protective earth (PE) conductor
mains supply Power feed
NO normally open (volt-free in open position)
NC normally closed (volt-free in closed position)
pwm Input for water meter with pulse output (option)
sensor Sensor
system pressure System pressure sensor input
vessel pressure Vessel pressure sensor input
temperature Temperature sensor input
FC out FC out
ohmic load Ohmic load, resistance
motor ball valve Motor ball valve
level switch Level switch / float switch / dry run protection
pressure switch Pressure switch controlled degassing
refill Top-up
release FC release FC
standby standby
mains supply Mains feed
GND/AGND/GNDA Mass (A=analogue, only connected as per terminal diagram)
out analogue out analogue