flamco MeiTronic W10, User Manual

Page: 87 / 232

87 Installation manual
EN
CONNECTION OF
CABLES AND SENSORS
Introduce the cables into the controller through the opening in the lower side or
through the bottom of the controller. First connect all zero conductors, then all
earthing conductors and in the end the inlet conductor and all relay outputs
from the left side to the right side.
Arrange the cables in the following manner:
FIRST FEEDTHROUGH - power supply, relay R1, relay R2;
SECOND FEEDTHROUGH - relay R3, relay R4, relay R5; …
Arrange the sensor cables in the following manner:
FIRST FEEDTHROUGH - T1, T2, T3;
SECOND FEEDTHROUGH - T4, T5, T6; ...
T1 T2 T3
N L R1 R6 R4 R3 R2 R5 R7 R8
IP20
Pt1000
Tamb 0-40°C
FUSE T4A 1 (1) A, 230 V~
L’ X
T5 T6 GND
COM BUS
T4
4 (1) A, 230 V~
230 V~
50 Hz
T7 T8