Fisher PLC-XU10N, Owner'S Manual

Page: 17 / 48

17
BEFORE OPERATION
Remote Control Batteries Installation
1 2 3
Slide the lid
upward.
Press the lid
downward and
slide it.
For correct polarity (+ and –), be sure
the battery terminals are in contact
with the pins in the compartment.
Remove the battery
compartment lid. Slide the batteries into
the compartment. Replace the compartment
lid.
Operating Range of the Remote Control
To insure safe operation, please observe the following precautions :
●
Use (2) AA type alkaline batteries.
●
Replace two batteries at the same time.
●
Do not use a new battery with a used battery.
●
Avoid contact with water or liquid.
●
Do not drop the remote control unit.
●
If batteries have leaked on the remote control, carefully wipe the case clean and load new batteries.
Point the remote control toward the projector (Receiver Window) whenever pressing the buttons. Maximum
operating range for the remote control is about 16.4’ (5m) and 60° front and rear of the projector
16.4'
(5 m)
60°
16.4'
(5 m)
60°