Lit. No. 44224, Rev. 14
92
August 15, 2011
MAINTENANCE
XtremeV™ CUTTING EDGE WEAR and
LEVELING ADJUSTMENT PROCEDURE
After the snowplow has been installed on the
vehicle in the correct con
fi
guration, a
fi
ne
adjustment can be made to bring the cutting
edges of the snowplow in full contact with the
ground across the entire cutting edge. This
adjustment feature should be used as the cutting
edges begin to wear in order to maintain an even
wear pattern across both cutting edges and
provide good scraping action.
1. Snowplow must be installed on a properly
ballasted vehicle, in the correct con
fi
guration.
2. Vehicle and snowplow must be on a level
surface.
3. Place the blade wings in the scoop position on
the ground with no tension on the lift chain.
4. Remove the rear push assembly to T-frame
fasteners. Loosen the front fasteners and
allow the blade to
fi
nd a level position.
Push
Assembly
T-Frame
Rear
Fasteners
Front
Fasteners
Summary of Contents for Minute Mount 2 system
Page 3: ......
Page 111: ...Lit No 44224 Rev 14 112 August 15 2011 NOTES ...
