Lit. No. 44224, Rev. 14
59
August 15, 2011
5. After entering the correct security code, the
power indicator light will change from
fl
ashing
rapidly to a solid light to indicate the snowplow
has been successfully unlocked.
NOTE: If the plow/vehicle electrical
connection is lost or disconnected, the
SECURITY GUARD™ system will reset,
requiring any control that is not programmed
with the established 4-digit security code to
manually re-enter the security code to activate
the snowplow.
Clearing an Established
4-Digit Security Code
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. If the snowplow is locked (the control power
indicator light will be
fl
ashing at a fast rate),
unlock the snowplow by following the Manual
Unlock procedure.
3. Move the ON/OFF switch to the "OFF"
position or push the ON/OFF button to switch
the control OFF. Verify that the power indicator
light is OFF.
4. With the control OFF, move the control lever
to the #2 position or press the #2 button
four consecutive times, and then to the #3
position or the #3 button four consecutive
times. This sequence (2, 2, 2, 2, 3, 3, 3, 3)
will clear the 4-digit security code from the
SECURITY GUARD system. The FLOAT light
will
fl
ash to indicate that the 4-digit security
code was cleared.
NOTE: To enter a new 4-digit security code
see Activation & Establishing a 4-Digit
Security Code.
OPERATING YOUR SNOWPLOW
Summary of Contents for Minute Mount 2 system
Page 3: ......
Page 111: ...Lit No 44224 Rev 14 112 August 15 2011 NOTES ...
