Lit. No. 44224, Rev. 14
57
August 15, 2011
OPERATING YOUR SNOWPLOW
SECURITY GUARD™ SYSTEM
Activation & Establishing a 4-Digit
Security Code
NOTE: The snowplow must be attached to
the vehicle, and all the electrical connections
must be connected prior to activating the
security code function.
The SECURITY GUARD feature was developed
as an electrical anti-theft system. The system
provides a deterrent from theft and/or non-
permitted use by allowing you to electronically
lock the snowplow's hydraulic functions.
All multiplex snowplow controls come equipped
with the SECURITY GUARD system. To use
this function, you must complete the "Activation"
process.
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position. (It is not necessary
to start the vehicle.)
2. Verify the control power indicator is OFF. If the
power indicator light is red, the control is ON.
Move the ON/OFF switch to "OFF" or push the
ON/OFF button to turn the control OFF.
3. To activate the SECURITY GUARD mode,
move the control lever to the #1 position or
press the #1 button four consecutive times,
and then to the #4 position or the #4 button
four consecutive times (sequence: 1, 1, 1, 1,
4, 4, 4, 4). The green FLOAT light will
fl
ash
quickly and the red power indicator light will
turn ON, indicating the system is ready to
accept your 4-digit security code.
Enter your 4-digit security code by moving the
control lever to (or pressing the button for) any
of the eight following positions: UP, DOWN,
LEFT, RIGHT, 1, 2, 3 or 4.
Summary of Contents for Minute Mount 2 system
Page 3: ......
Page 111: ...Lit No 44224 Rev 14 112 August 15 2011 NOTES ...
