Installation Instructions
Seite/Page 90 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions
26.1.11
5.5.3 Position of the pre-filter with water separator
Fig. 5.5.3-1: Fuel filter with water separator
Additionally to the standard fine filter a prefilter with water
separator must be installed outside of the sound cover in the
fuel system line. (is not included in delivery.)
5.6
Generator 12V DC System-Installation
The Panda 4000s needs a battery with a capacity of at least 44Ah for the start. The generator can be attached to the
existing starting battery of the main engine or be supplied with its own battery.
The Panda 4000s is not equipped with its own 12V battery loading installation. Thus that the starting battery is char-
ged during the generator operation, at the exit of the generator a battery charger is ensured is normally attached.
This battery charger should be selected in such a way that the rated output approx. 10% of battery capacity corre-
spond. (120Ah starting battery requires a battery charger with approx. 10 - 12A charging current).
In the Panda accessories program special battery chargers are available, which are designed to load in connection
with the generator particularly effectively. This is however necessary only if the electrical system is to be loaded
hereby. For loading the generator and/or starting battery a simple, low-priced battery charger is sufficient.
5.6.1 Connection of the 12V starter battery
Attention!:
Use the prepared protective tube for the battery (+) cable.
