CM6300
Install Guide
Alarm System
www.firstechonline.com | www.compustar.com
Firstech technical support is reserved for authorized dealers only.
Monday - Friday:
888-820-3690
(8:00 am – 5:00 pm Pacific Coast Time)
Email:
Web:
www.compustar.com/dealersupport
Wire Diagrams
Click on the “Installogy Access Client” link found on your desktop. If you are a qualified dealer and unable
to access this site, call your sales representative or the number above.
Technical Support Contacts
CM6300
Copyright 2012 Firstech, LLC.
Page 32
Do the door locks flip flop in polarity?
A: No. You can use the CompuPack (relay pack) for high current positive (+) locks, or the DM600 harness
used for low current 600mA positive (+) locks.
What are Firmware Version Diagnostics?
A: When you turn the Ignition on and hold buttons 1 and 4 or Lock and Key/Start for 2.5 seconds then the
parking lights will flash 1 time on the CM6 series showing V.1 and so forth. Current version 3.11 should
show 3 flashes when triggered.
What is this cartridge slot on the rear of the CM6300?
A: This is the slot for the Blade cartridge system. This slot is for the Idatalink Blade remote start bypass
modules. For more information on the compatibility and install information please visit www.idatalink.com/
fitguide. Using this system eliminates many connections between your standard control module and bypass
module.
IMPORTANT:
If you are not using the Blade then you will not have or use the 20 pin connector
next to the back up battery port.
I’m using the RPS Touch but my LED’s and Secure Valet LED does not flash.
A: The CM6000 and CM6300 LED and Secure Valet LEDs will not work when using an RPS Touch. This is a
hardware limitation. The RPS 2 will work with LEDs and Secure Valet.