The CM6 Series Blade connector has a locking tab. Older blade harnesses will work but you must cut the
notches on the black harness plug off.
Blade system includes:
1. Blade-AL or Blade-TB (NOTE: These modules are blank and must be flashed on your computer.)
2. 20 Pin locking wiring harness
3. 3 Pin harness used in some installs
IMPORTANT:
Install diagrams are not included and must be downloaded from www.idatalink.com/
compustar. When flashing the Blade you can use the Y-Cable OP500 end and not CM4 Series end. ADS
and Firstech recommends using the 4 pin RS232 cable to avoid confusion. Cartridge must be removed to
flash the control module firmware.
NOTE:
The ADS-RNG C1, ADS-RNG C2, and ADS-RNG GM3 are not included and must be purchased
separately. The 20 pin Blade connector comes only with the Blade cartridge and not the CM6 control
modules.
WARNING:
Manufacturer or seller assumes no responsibility for any injuries and/or damages caused by
improper care of the product such as decomposition, conversion, and transform done by a user voluntarily.
WARNING:
There should be no wiring routed around any pedals which can cause a driving hazard.
Wiring Descriptions
CM6300
CM6300
Install Guide
Alarm System
www.firstechonline.com | www.compustar.com
Copyright 2012 Firstech, LLC.
Page 13
STEP 4:
The control modules have a secure auxiliary option 4-05. This requires you to tap button 4 before you tap button 2 for
Aux 1 or button 3 for Aux 2. On 1-Way remotes you must hold the Trunk and Key/Start buttons for 2.5 seconds then tap the Trunk
button for Aux 1 or the Key/Start button for Aux 2.
STEP 5:
If you need to change the time settings of the outputs go to AU1 or AU2 on the OP500. LCD Line 2 is the timed output.
STEP 6:
Hold the “W” Write button for 3 seconds to set all the options.
Version Diagnostics
All the new control modules come with the ability to check which firmware is on the module. This is
accomplished by turning the ignition on. Then with 2 Way remotes you must hold buttons 1 and 4 together
for 2.5 seconds. With the 1 Way remotes you must hold the Lock and Key/Start buttons together for 2.5
seconds.
Blade Cartridge Slot and Connector
The slot gives you the ability to use the Blade-AL and Blade-TB modules from Firstech and ADS. With these
modules you can virtually eliminate all wire connections between your control module and bypass module.
You only need to connect the main ignition harness and your required wires on the 20 pin Blade connector.
For more information on how to program and wire the Blade please visit www.idatalink.com for the specific
wiring diagram for that vehicle.