4
SAFETY INFORMATION
WARNING: The equipment in this manual is capable of causing property damage, severe
injury or death. It is the responsibility of the owner or user to ensure that the equipment
described herein is installed, operated and commissioned in compliance with the requirements
of all national and local legislation which may prevail.
When this equipment is mounted on a burner/boiler, due regard must be given to the requirements of
that appliance.
Before attempting to install, commission or operate this equipment, all relevant sections of this
document must be read and fully understood. If in doubt about any requirements consult the
supplier. Installation, commissioning or adjusting of this product MUST be carried out by suit-
ably trained engineers or personnel qualified by training and experience.
The manufacturer of this equipment accepts no liability for any consequences resulting from the
inappropriate, negligent or incorrect installation, commissioning or adjustment of operating parame-
ters of the equipment.
This equipment MUST only be mounted on to burners as detailed in the contracted specification.
The supplier must approve any change in the specification in writing.
Control panels MUST NOT be left uncovered while power is on. If it is essential to do so while rec-
tifying faults, only personnel qualified by training and experience should be involved.
The time any covers are off must be kept to a minimum and warning notices MUST be posted.
Before attempting any work on this equipment, the electrical supplies MUST be isolated.
Safety interlocks MUST NOT be removed or over-ridden. Any faults detected MUST be corrected
before the unit is operated.
CAUTION: Some versions of this equipment contain a lithium battery.
Note: The manufacturer of this equipment has a policy of continual product improvement and
reserves the right to change the specifications of the equipment and the contents of this manual with-
out notice.
WARNING: Explosion of fire hazard can cause property damage, severe injury or death. To
prevent possible hazardous burner operation, verification of safety requirements and inter-
locks must be performed each time a control is installed on a burner.