Fireye D30 Series, Manual

Page: 4 / 24

4
£
ORDERING INFORMATION
Each complete Fireye Series D30 system includes:
1. A control chassis and cover.
2. A plug-in Programmer.
3.
A plug-in Amplifier.
4. A flame scanner.
5.
A wiring base.
To specify a control system which provides 30 seconds prepurge, with infrared (AUTOCHECK)
flame detection for surface mounting, select the following:
70D30 Control and Cover
71D80 Programmer
72D1R1 Amplifier
48PT2 Flame Scanner (specify length and mount)
60-1386 Wiring Base
Note: When a Fireye C-Series unit is replaced with a D-Series unit, the chassis retaining clip (for
quarter turn fastener) in the wiring base must be replaced with a threaded clip that is supplied with
each D-Series control.
Fireye Series D30 controls supersede similar Fireye C-Series controls and are directly plug-in inter-
changeable.
CAUTION: While all controls in the D-Series are mechanically interchangeable in that they
mate with a common wiring base, you should select the correct model for your application.
Inappropriate application of a control could result in an unsafe condition hazardous to life
and property. Selection of a control for a particular application should be made by a compe-
tent professional, such as a boiler/burner service technician licensed by a state or other gov-
ernmental agency.
INSTALLATION
CAUTION: Installer must be a trained safety control technician. Verify that Electrical
Power is disconnected before starting installation.
Follow the burner manufacturer’s instructions, if supplied. Otherwise proceed as follows:
Wiring Base
Mount the control wiring base on the burner or on a panel. The location should be free from exces-
sive vibration and within the specified ambient temperature rating. The base may be mounted in any
angular position.
All wiring should comply with applicable electrical codes and be suitable for 75
q
C min. The termi-
nals in the wiring base permit a variety of connection methods — wire loop, eyelet, lug or quick con-
nect. A green grounding terminal is provided for equipment bonding. Circuit recommendations are
provided later in this document. Consult with the factory for assistance with non-standard applica-
tions.
REMOVING OLD CLIP REPLACING NEW CLIP