Maintenance Programming Level
Programming
MS-9200UD PN 51906:A 12/10/02
125
Pressing
3
while viewing Program Check screen will cause a screen similar to the
following to be displayed:
The Zone No Output feature allows the programmer to view the zones which have not
been programmed to at least one output device (not including general alarm Zone 00).
The example in the preceding screen indicates that Zones 05, 07, 09, 10 and 11 have
been programmed to an addressable detector with an address of 001 on loop 1 but have
not been programmed to any output devices. Use the up and down arrow keys to view
all the zones without output assignments.
3.7.4 Walktest
To perform a walktest, press
1
while viewing Maintenance Screen #2. The following
screen will be displayed:
The operator can press
1
to perform a silent walktest or
2
to perform an audible
walktest. The display will read
UNIT IN WALKTEST
. To end the Walktest, press the
Esc (Escape) key.
Pressing
3
after the walktest has been completed, will allow the operator to view the
results of the walktest.
3.7.5 System
To program the time and date into the control panel, press
2
while viewing Maintenance
Screen #2. The following display will appear:
ZONES NO OUTPUT
05 07 09 10 11 1D001
PROGRAMMING
1=WALKTEST
2=SYSTEM
3=ZONE SETUP
Maintenance Screen #2
WALKTEST
1=SILENT
2=AUDIBLE
3=VIEW RESULT
Walktest Screen
SYSTEMS
1=TIME/DATE
System Screen
Summary of Contents for MS-9200UD
