Operating instructions FS-26E
Status as of 10 / 2019
Page 29
Parameter: Dropout delay S1 [s]
Code A and B
Value can be set from 0.0 - 9.9
Increment 0.1 s
Depending on the physical state of the relay output
and the inversion by F2, a logical result is output.
If
the
logical
result
is
1, the logical, further processable
state (feedback) is passed on as 1, delayed by the time S1.
Otherwise, the state remains as is.
Parameter: Pick-up delay S1 [s]
Code A and B
Value can be set from 0.0 - 9.9
Increment 0.1 s
Depending on the physical state of the relay output
and the inversion by F2, a logical result is output.
If
the
logical
result
is
0, the logical, further processable
state (feedback) is passed on as 0, delayed by the time S1.
Otherwise, the state remains as is.
Parameter: Logic [function]
Code A and B
Value can be set to O, U, S
Result = physical state of the relay output before the
function
F1.
O
-
OR
operation
of
all
available
and active (value entry 0.LEX=1) inputs and active
(0.LAX=1)
outputs
(feedback)
U
-
AND
operation
of
all
available
and active (value entry 0.LEX=1) inputs and active
(0.LAX=1)
outputs
(feedback)
S - ACCUMULATION operation of all available
and active (value entry 0.LEX=1) inputs and active
(0.LAX=1)
outputs
(feedback)
AND
operation
to
switch
off
OR
operation
to
switch
on
again
Parameter: Input E2 [function]
Code A and B
Value can be set to 0 or 1
0
-
Input
switched
to
inactive (not considered in the logic)
1 - Input switched to active (considered in the logic)
Parameter: Input E3 [function]
Code A and B
Value can be set to 0 or 1
0
-
Input
switched
to
inactive (not considered in the logic)
1 - Input switched to active (considered in the logic)
