Fimar TS1, Use And Maintenance

Page: 39 / 154

- 17 - English language
346-
075-0.
fm
ID
M
HEAT SEALERS
TSAVG
EN
Programming the work parameters
The procedure is used for programming the parameters of a new work program, overwriting
a pre-existing one which will be deleted.
1. Press button
(A6) .
2. Select the program to be overwritten using the buttons (A4-A5) .
3. Press button (A7) to confirm the selection.
4. Press button (A3) .
5. Set the sealing time using the buttons (A4-A5) .
6. Press button (A7) to confirm the selection.
7. Set the sealing temperature using the buttons (A4-A5) .
8. Press button (A7) to confirm the selection.
9. Set the vacuum percentage using the buttons (A4-A5) .
10.Press button (A7) to confirm the selection.
11.Set the inert gas percentage using the buttons (A4-A5) .
12.Press button (A7) to confirm the selection.
The parameters are stored in the new work program.
LOADING THE REEL
1. Rest the film reel (P) on the support (B) .
2. Pull out the container support (C) com-
pletely.
3. Insert the film in the film holder (Q) and
block it on the back of the container sup-
port
(C) as shown in the figure.