S.CON1M/MA System
25
(M)odify any of this or (C)ontinue? [M] m
For each of the following questions, you can press <Return> to select the value shown in braces,
or you can enter a new value.
NETWORK PARAMETERS:
-------------------
Do you want a LAN interface? [Y]
This board's LAN IP address(0.0.0.0 = RARP)? [192.168.1.79]
Use a subnet mask for the LAN interface? [N] y
Subnet mask for LAN (0 for none)? [0.0.0.0]
Should there be a default gateway for packet routing? [N] y
What is its IP address? [0.0.0.0]
CONSOLE PARAMETERS:
-------------------
Baud rate for serial channels [9600]
ETHERNET PARAMETERS:
--------------------
Do you want to change the board's Ethernet address? [N] y
Byte 0 must be 00
What should byte 1 be? [A0]
What should byte 2 be? [D2]
What should byte 3 be? [2F]
What should byte 4 be? [80]
What should byte 5 be? [82]
SNMP PARAMETERS:
----------------
Get community [public]
Set community [private]
Trap destination 1 [192.168.1.15]
Trap destination 2 [0.0.0.0]
Trap destination 3 [0.0.0.0]
Trap destination 4 [0.0.0.0]
Trap community [trap]
System name []
System location []
System Contact []
User name [moose]
Password [1234]
How long (in seconds) should CPU delay before starting up? [3)
Figure 2
– system configuration
Network parameters
•
IP address
: specify here the IP address you wish to assign to the device.
This parameter must be set correctly (according to your network) in order to
remotely control and monitor your media converter from a management
station.
•
Subnet mask
: specify the required subnet mask to use within the network.
•
Default gateway
: specify the default gateway to be used by the module.
Console parameters
•
Baud rate
: set the baud rate of communication between converter and terminal.
It
is recommended to leave this setting at default value (9600)
SNMP parameters
•
Get community
: specify the get community string for the media
converter. (max. 15 characters)
•
Set community
: specify the set community string for the media
converter. (max. 15 characters).
