FiberHome AN5516-04, Quick Installation Manual

Page: 29 / 36

17.2
Connecting the Optical Fiber Inside the
 Bind all wires and cables used in onsite in
separately. For example, power cables, a
independently and bound separately. Note
fiber binding straps.
 Exercise care if you must bend fibers. If b
never be less than 20 d (d: fiber diameter)
Route the optical fibers along the wiring chann
subrack.
Caution
1
Lead the optical fibers through the fiber passa
Connect the optical fibers to the optical interfa
2
3
17.3
Arrangement after Layout
After the connection of the optical fibers is com
entrance of the cabinet and at the point near th
secure them.
Connect the optical fiber on the ODF side.
Remove the temporary labels; make project la
1
2
3
25
Caution
Remove the temporary labels; make project la
Do not leave the label between two cards, wh
cards.
The optical interfaces not connected with fiber
fiber pigtails not connected
with optical interfaces should be covered with
3
4
Cabinet
nstallation. Each cable type should be bound
larm cables and optical fibers should be laid out
e that optical fibers should be bound with dedicated
ends are necessary, the fiber bending radius should
).
nel on the cabinet to the fiber passage area of the
age unit of the subrack.
aces on the corresponding card.
mpleted, installers should bind the optical fibers at the
he fiber passage area with dedicated fiber binders to
abels and attach them to both ends of the optical fiber
5
abels and attach them to both ends of the optical fiber.
hich may affect the electrical conductivity between
r pigtails should be covered with anti-dust caps. The
pigtail caps.