FiberHome AN5516-04, Quick Installation Manual

Page: 23 / 36

Subrack Power
Cable
Power Interface on the PWR
DC power cable
The subrack power cable is shown in the tab
Caution
Note
Make sure that the power control switches fo
subrack on the PDP are placed in the OFF po
Connection
Connect the blue and black cord end terminals
interfaces on the PDP. Connection of the subra
may vary with the PDP used. Refer to the table
Lead the subrack power cable through the PDP
power cable to the power interface of the power
side of the cabinet.
Insert the D-type two-conductor connector of the
PWRD card, and tighten the screws clockwise.
1
2
3
19
Cable Connector
Connection Descriptio
PDP296B (3000068)
Cord end terminal
(-48 V, blue)
Connected to the -48V_
to -48V_B_3 terminals (
Cord end terminal
(0 V, black)
Connected to the 0V_A
0V_B_3 terminals (stan
D-type two-conductor
connector
Connected to the PWRD
AN5516-04 subrack.
RD Card Power Cable Equipped
le below.
r the corresponding
osition.
0 V black cable
-48 V blue cable
1
Cross
screwdriver
Flat
screwdriver
of the subrack power cable to the corresponding
ck power cables for the AN5516-04 on the PDP side
below for details.
P wiring hole on the top of the cabinet. Route the
r card in the subrack along the wire channels on the
e subrack power cable into the power interface of the
9
on
_A_1 to 48V_A_3 terminals (active) and -48V_B_1
(standby) on the PDP.
A_1 to 0V_A_3 terminals (active) and 0V_B_1 to
ndby) on the PDP.
D power input interface on the backplane of the