Festo Smart cubic CPV-SC Series, Manual

Page: 61 / 80

5. Maintenance and conversion
5-5
Festo P.BE-CPVSC-EN en 0112NH
Remove the components
1. Unclamp the valve block. Loosen the tie rods one turn.
Unscrew the tie rods so that the screw heads project up
to 9 mm out of the end plate (do not remove the tie rods).
2. Pull the valve terminal apart so that there is a gap of at
least 2 mm to the left and the right of the component to
be replaced.
3
1
2
1 Components to be replaced
2 Tie rod
3 2 mm gap to the left and right of the
component to be replaced
Fig. 5/1: Loosening the tie rods
3. When the double-solenoid valve Ident. code J is removed,
both valve plates and the ”control” and ”work valves”
must also be removed.