B
Diagnostic messages
64
Festo – GDCP-CMMD-AS-HW-EN – 1404NH – English
Error group 29
SD card
no.
Reaction
Message
Code
29-2
7682h
SD parameter set error
configurable
Cause
–
Checksum incorrect.
–
File not present.
–
File format incorrect.
–
Error saving the parameter file on the SD card.
Action
•
Check content (data) of the SD card.
Error group 31
I²t monitoring
no.
Code
Message
Reaction
31-0
2312h
I²t error motor (I²t at 100%)
configurable
Cause
I²t monitoring of the controller has been triggered.
–
Motor/mechanical system blocked or sluggish.
–
Motor under-sized?
Action
•
Check motor and mechanical system.
31-1
2311h
I²t error controller (I²t at 100%)
configurable
Cause
I²t monitoring of the controller has been triggered.
Action
•
Check power dimensioning of drive package.
Error group 32
Intermediate circuit
No.
Code
Message
Reaction
32-0
3280h
Intermediate circuit charging time exceeded
PS off
Cause
The intermediate circuit could not be charged after the mains
voltage was applied.
–
Fuse possibly defective.
–
Internal braking resistor defective.
–
In operation with external braking resistor, the resistor is not
connected
Action
•
Check mains voltage (intermediate circuit voltage < 150 V)
•
Check interface to the external braking resistor.
•
If the interface is correct, the internal braking resistor or the built-in
fuse is presumably faulty
Repair by the manufacturer.
32-8
3285h
Power supply failure during controller enable
PS off
Cause
Interruption/power failure while the controller enable was active.
Action
•
Check mains voltage/power supply.
